Notifications
Clear all
rosenstand
rosenstand
Group: Registered
Joined: 2019/03/17
Active Member
1
Clogging in top of organic supports

In forum Hardware, firmware and software help

1 year ago
@peter-c20 I use these (x 6):/p> They work really well and l...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
@max-distortion I’m afraid those are waaay too small/soft fo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@chocki I’m glad you’re impressed with them too 🙂 It’s craz...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@chocki Neat way to measure, thanks for the tip 🙂 I would e...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@chocki I would ask the seller if they’re 1,25 inch (roughly...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@chocki remember to do a rough weight calculation and order ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Thanks bobstro. As I said I did run the printer on a paver f...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Thanks choki, although too late for me it might be helpful f...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Ok, so I finally got all parts and time to install them. I d...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@chocki That’s my backup plan 🙂 I would prefer to avoid a g...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
@robert-rmm200 I don’t think it’s any louder than any other ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Where to get Sorbothane feet in Europe

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
I was thinking about either adding a thin paver on top of th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Mounting on a sand bag?

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
Thanks a lot! I was using default SlicerPE values for Prusam...

In forum Assembly and first prints troubleshooting

6 years ago
Failing large prints

In forum Assembly and first prints troubleshooting

6 years ago
Share: