Prusa3D Forum

Notifiche

Cancella tutti

Ropefish

Gruppo: Registrato

Registrato: 2022/05/27

Active Member

	Well got a replacement bearing, sound was gone for a while. ... Nel forum Hardware, firmware and software help	3 years fa
	Idler runs smooth, the belt sits to the right slightly more ... Nel forum Hardware, firmware and software help	3 years fa
	Here is a video of the sound as it is now after tightening t... Nel forum Hardware, firmware and software help	3 years fa
	Well not even two prints later, its back. the belt is still ... Nel forum Hardware, firmware and software help	3 years fa
	I checked the belts and noted that they would not get over t... Nel forum Hardware, firmware and software help	3 years fa
	It is always the same sound no matter the infil type. Nel forum Hardware, firmware and software help	3 years fa
	Y-Axis Rattle Nel forum Hardware, firmware and software help	3 years fa

Statistiche Forum

585 Forum

68.1 K Discussioni

477.1 K Post

12 Online

75.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso