Prusa3D Forum

Notifications

Clear all

roon4660

Groupe: Enregistré

A(ont) rejoint: 2020/08/27

Active Member

	@neophyl I could turn on M600 if I could get arduino to coop... Dans le forum PrusaSlicer	il y a 4 years
	I should check my writing before I send. Sorry. Dans le forum PrusaSlicer	il y a 4 years
	I just took a look at it and that because I was a buiolder (... Dans le forum PrusaSlicer	il y a 4 years
	@neophyl I have to do this tomorrow. I' 75 yo and I had a co... Dans le forum PrusaSlicer	il y a 4 years
	@neophyl That makes total sense. I am trying what you gave m... Dans le forum PrusaSlicer	il y a 4 years
	Yes it seems to have worked. Thanks for teaching me somethin... Dans le forum PrusaSlicer	il y a 4 years
	@neophyl I had the same results when the supports had the li... Dans le forum PrusaSlicer	il y a 4 years
	@neophyl Celina_kids_litho.3mf I hope this will do the trick... Dans le forum PrusaSlicer	il y a 4 years
	Support enforcers disappear when I slice. Dans le forum PrusaSlicer	il y a 4 years
	I have watched three tutorials on using support enforcers an... Dans le forum PrusaSlicer	il y a 4 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.4 K Messages

21 En-ligne

68.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé