|
Sorry for the late response!! I was not aware of volumetric ... In forum How do I print this? (Printing help) |
4 weeks ago |
|
Hi! I just uploaded the project file. Feel free to check it ... In forum How do I print this? (Printing help) |
2 months ago |
|
Hi! I just uploaded the 3mf project file to the thread. Yes,... In forum How do I print this? (Printing help) |
2 months ago |
|
Here is the 3MF file!
0cbe47f8-torre-espana-pragm... In forum How do I print this? (Printing help) |
2 months ago |
|
Thank you for your answer! I was not meaning the layer stepp... In forum How do I print this? (Printing help) |
2 months ago |
|
Weird surface artifacts In forum How do I print this? (Printing help) |
2 months ago |
|
Ordered at 17:44, black trim without extras. Still at "New -... In forum General discussion, announcements and releases |
2 years ago |
|
Good morning! Thank you so much for your feedback! I will st... In forum How do I print this? (Printing help) |
3 years ago |
|
Ok, I’ll take a look at that, thanks 🙂 Do you know why the ... In forum How do I print this? (Printing help) |
3 years ago |
|
Here is the 3mf if needed! Patas PRUEBA 1-10.3mf In forum How do I print this? (Printing help) |
3 years ago |
|
Hi! Sorry for the delay, I tried doing what you just told, t... In forum How do I print this? (Printing help) |
3 years ago |
|
I think you may be correct on this one, it was a 5mm diamete... In forum How do I print this? (Printing help) |
3 years ago |
|
It was a 5mm diameter road so maybe it was printing over non... In forum How do I print this? (Printing help) |
3 years ago |
|
Cylinder printing advise In forum How do I print this? (Printing help) |
3 years ago |
|
Hello again, I printed your latest support-less 3mf, turned ... In forum How do I print this? (Printing help) |
4 years ago |
|
Good morning! Thank you so much for those new 3mf, I will gi... In forum How do I print this? (Printing help) |
4 years ago |
|
Hello again! This time it’s really near perfect, the layer i... In forum How do I print this? (Printing help) |
4 years ago |
|
Good morning! Thank you @swiss_cheese ! I will run that code... In forum How do I print this? (Printing help) |
4 years ago |
|
Here are the results right now. After some cleaning and lubr... In forum How do I print this? (Printing help) |
4 years ago |
|
Here is a little update, the part that I printed at 215º loo... In forum How do I print this? (Printing help) |
4 years ago |