Prusa3D Forum

Notifications

Clear all

Rocket printer

Groupe: Enregistré

A(ont) rejoint: 2023/12/21

Active Member

	I'm having that issue on the z steppers any ideas? Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Hi Kyle, The way to do that would be to redo first layer c... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Have gotten a m 0.5 on my mk3s+ in .05mm ultra detail (.25 n... Dans le forum How do I print this? (Printing help)	il y a 2 years
	If you like these rockets check out these rocket on printabl... Dans le forum Awesome prints (Hall Of Fame)	il y a 2 years
	Is this possible with an MK3s+, Thanks Dans le forum PrusaSlicer	il y a 2 years
	Z axis gets stuck and shows wrong height Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	I have tried all methods so this leaves cutting the visible ... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Thanks for the suggestions. I already tried options 1 and 2,... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Stripped Screw and Stripped Screw hole on extruder Dans le forum Assembly and first prints troubleshooting	il y a 2 years

Statistiques du forum

595 Forums

68.8 K Sujets

481.4 K Messages

15 En-ligne

77.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé