|
I've mentioned it before on these forums - you can lower the... In forum How do I print this? (Printing help) |
8 years ago |
|
No need to change firmware, just add M302 S170 to your start... In forum General discussion, announcements and releases |
8 years ago |
|
Unfortunately, it'll be nearly impossible to really verify i... In forum Others (Archive) |
8 years ago |
|
I'm updating this to see what it is like with only 2 exits a... In forum Others (Archive) |
8 years ago |
|
I've got the same issue with my filament sensor. It was work... In forum Others (Archive) |
8 years ago |
|
It’ll be fairly easy to add a second model with no front coo... In forum Others (Archive) |
8 years ago |
|
Another alternative MK3 part cooling duct In forum Others (Archive) |
8 years ago |
|
I've been using that as well as merging the pull request fro... In forum Others (Archive) |
8 years ago |
|
That'll be it getting mixed up between relative extrusion mo... In forum Others (Archive) |
8 years ago |
|
I'm using the matte black Printbite+ on my MK2 at the moment... In forum Prusa i3 kit (Archive) |
8 years ago |
|
It's not too think but it is very close - you need to move t... In forum Others (Archive) |
9 years ago |
|
I've also successfully assembled the titan. Not had much tim... In forum Improvements (Archive) |
9 years ago |
|
Wouldn't this only work if we all had the same Z distance fr... In forum Others (Archive) |
9 years ago |
|
I can say from experience that even 1.5mm is WAAAAAY too muc... In forum Others (Archive) |
10 years ago |
|
Can you share a copy of your FFF? My question is this extru... In forum General discussion, announcements and releases |
10 years ago |
|
So, how do you guys save your material configs in S3D? I'm g... In forum General discussion, announcements and releases |
10 years ago |
|
This stuff works as well - Much cheaper too.
I followed th... In forum Prusa i3 kit (Archive) |
10 years ago |
|
My Bad, Slic3r warms both bed and hotend at the same time, I... In forum General discussion, announcements and releases |
10 years ago |
|
Another Filament Guide In forum Improvements (Archive) |
10 years ago |
|
My Mk2 came with the old heater block and thermistor, so I o... In forum Improvements (Archive) |
10 years ago |
