Notifications
Clear all
RobertB67
RobertB67
Grupa: Zarejestrowany
Dołączył: 2017/10/21
Trusted Member
3
getting 5v from Einsy Board?

In forum Hardware, firmware and software help

6 years temu
I've been critical of Prusa in some of my post, but they are...

In forum General discussion, announcements and releases

6 years temu
Powder Coated PEI Sheet all the way. Would not care if I eve...

In forum General discussion, announcements and releases

6 years temu
I didn’t get one either. Mine was ordered 12/14/2018.... ...

In forum General discussion, announcements and releases

6 years temu
I've been critical of Prusa in some of my post, but they are...

In forum General discussion, announcements and releases

6 years temu
Prusa autumn update: powder-coated sheets, MMU2 status updat...

In forum General discussion, announcements and releases

6 years temu
Prusa autumn update: powder-coated sheets, MMU2 status updat...

In forum General discussion, announcements and releases

6 years temu
I spoke to Prusa support a couple of weeks ago and they said...

In forum General discussion, announcements and releases

6 years temu
Prusa has the ability to provide sheets that are "done right...

In forum General discussion, announcements and releases

6 years temu
So 5 Days left of October and no news from PRUSA and since i...

In forum General discussion, announcements and releases

6 years temu
I found that prints stick better to the textured sheet and ...

In forum General discussion, announcements and releases

6 years temu
PC Textured sheet.

In forum General discussion, announcements and releases

6 years temu
Any news on Textured PC Sheets, 1 Year and still waiting

In forum General discussion, announcements and releases

6 years temu
Raise the bed to 60, it will help with bed adhesion. 😀 an...

In forum General discussion, announcements and releases

6 years temu
I am pretty sure mine are powder coated Nope, it's PEI Sti...

In forum General discussion, announcements and releases

6 years temu
did you have to cut som of the big parts i half and print se...

In forum Awesome prints (Hall Of Fame)

6 years temu
Well done, both the print and your photos. What filament and...

In forum Awesome prints (Hall Of Fame)

6 years temu
They are amazing. Do you recall the total print times for e...

In forum Awesome prints (Hall Of Fame)

6 years temu
I did not have to split any of the parts. One of the pieces ...

In forum Awesome prints (Hall Of Fame)

6 years temu
T-Rex @ 110% and 220%

In forum Awesome prints (Hall Of Fame)

6 years temu
Strona 2 / 5
Share: