Notifications
Clear all
Robert
Skupina: Registrovaný
Přidal se: 2018/01/21
Active Member
1
|
Well I was playing today and what I did was switch the drawi... In forum How do I print this? (Printing help) |
před 2 years | |
|
Yes, I use Fusion 360. That’s not the issue. If I draw the p... In forum How do I print this? (Printing help) |
před 2 years | |
|
Printing threads In forum How do I print this? (Printing help) |
před 2 years | |
| I reduced speed to 150 mm/s and it printed fine. So I guess ... | před 7 years | |
| Well it wasn't an over extrusion problem, it still does it. ... | před 7 years | |
| No, I don't think its a Z hop issue. I did check my extruder... | před 7 years | |
| How do I enable z hop? | před 7 years | |
| Printing question - troubleshooting | před 7 years | |
| I just updated my firmware to 3.1.3 and downloaded Prusa's f... | před 7 years | |
|
I finally got a label printed email this morning along with ... In forum Others (Archive) |
před 7 years |