|
F5'ing on the github for about a week now...
I've tried ev... In forum Hardware, firmware and software help |
před 9 months |
|
Leadscrew alignment helper: In forum Hardware, firmware and software help |
před 10 months |
|
I’m currently designing a little leadscrew alignement tool, ... In forum Hardware, firmware and software help |
před 10 months |
|
it is completely flat.
I think my assembled one is was a b... In forum Hardware, firmware and software help |
před 10 months |
|
My bed was too low at the middle back leadscrew, for around ... In forum Hardware, firmware and software help |
před 10 months |
|
Loosening the screws on the bearings did not help. But manua... In forum Hardware, firmware and software help |
před 10 months |
|
I printed around 10 xyz-cubes, they all seem to have correct... In forum Hardware, firmware and software help |
před 10 months |
|
Unfortunately that did not help. In forum Hardware, firmware and software help |
před 10 months |
|
That would mean the trapezoidal nuts are binding, or the bea... In forum Hardware, firmware and software help |
před 10 months |
|
Loosening the screws at the t-nuts did not help, unfortunate... In forum Hardware, firmware and software help |
před 10 months |
|
I think i already tried this, but will give it another try. ... In forum Hardware, firmware and software help |
před 10 months |
|
Thanks for the tip, i already put some ptfe grease on the le... In forum Hardware, firmware and software help |
před 10 months |
|
The weird thing is, i have 3 coreXY printers:
Bambu P1S ... In forum Hardware, firmware and software help |
před 10 months |
|
I have taken a first look, no clog so far.I have swapped noz... In forum Hardware, firmware and software help |
před 10 months |
|
Still not happy with the results.
Thinking about sending i... In forum Hardware, firmware and software help |
před 10 months |
|
I removed the printed part. My top panel is raised already s... In forum Hardware, firmware and software help |
před 10 months |
|
I think it did, just a bit, still not printing as good as my... In forum Hardware, firmware and software help |
před 10 months |
|
Think i found it. The last bend of the PTFE tube is too narr... In forum Hardware, firmware and software help |
před 10 months |
|
Ugly walls In forum Hardware, firmware and software help |
před 10 months |
|
Where did you get the Prusa parts from? are they already pu... In forum Hardware, firmware and software help |
před 10 months |
