Prusa3D Forum

Notifications

Clear all

rickr

Groupe: Enregistré

A(ont) rejoint: 2019/12/12

Active Member

	@sturmkraehe I wouldn't attempt to heat PLA beyond 250degC y... Dans le forum Hardware, firmware and software help	il y a 6 years
	I have smooth rod failures as well and replacement parts fro... Dans le forum Hardware, firmware and software help	il y a 6 years
	An ooze shield might work as a quick workaround for your pro... Dans le forum Hardware, firmware and software help	il y a 6 years
	I'd be very careful with what your planning on doing from a ... Dans le forum Hardware, firmware and software help	il y a 6 years
	I just use 70% IPA and I rub the surface with a lint-free ti... Dans le forum Hardware, firmware and software help	il y a 6 years
	The printer I got for my workplace is also exhibiting a fail... Dans le forum Hardware, firmware and software help	il y a 6 years
	@robert-rmm200 Its a pre-assembled printer as in Prusa assem... Dans le forum Hardware, firmware and software help	il y a 6 years
	Prusa is sending me replacement parts so hopefully that will... Dans le forum Hardware, firmware and software help	il y a 6 years
	Pre-assembled printer x-axis bearing failure in Dans le forum Hardware, firmware and software help	il y a 6 years

Statistiques du forum

585 Forums

68.1 K Sujets

477 K Messages

9 En-ligne

75.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé