|
Updated y-axis belt holder fixed my slipping belt issue. Nel forum Hardware, firmware and software help |
5 years fa |
|
@aladdinsane, it could've been the fact that my y-axis belt ... Nel forum Hardware, firmware and software help |
5 years fa |
|
Part was F2. Replaced with R1 and it definitely was tougher ... Nel forum Hardware, firmware and software help |
5 years fa |
|
Y-Axis Belt keeps slipping, getting loose Nel forum Hardware, firmware and software help |
5 years fa |
|
Thanks @bobcousins. I redid the wizard, first layer calibrat... Nel forum Hardware, firmware and software help |
5 years fa |
|
Also to add to it, I've been printing with Prusament PLA, Ov... Nel forum Hardware, firmware and software help |
5 years fa |
|
Idler Gear clicking since updating to 4.0.5 Nel forum Hardware, firmware and software help |
5 years fa |
|
So after not printing for a few days and starting back up, I... Nel forum Assembly and first prints troubleshooting |
5 years fa |
|
I noticed the belt being not centered on the pulley on my pr... Nel forum Assembly and first prints troubleshooting |
5 years fa |
|
Yeah my mini makes the same noise at the X-axis bearing end.... Nel forum Assembly and first prints troubleshooting |
5 years fa |
