richard.l – Activité – Prusa3D Forum

Notifications

Clear all

richard.l

Groupe: Modérateur

A(ont) rejoint: 2015/10/29

Titre: Membre Moderator

	Genius idea. I'll try the cling film and see what happens. Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Had it with the glass /clips setup as well as with the gecko... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Yes, I am running the latest firmware. It's like the holes ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Print bed vibration Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Guys, Thanks for the tips. I managed to get everything sort... Dans le forum Software (Archive)	il y a 10 years
	Ok, I now have what I believe to be all my errors worked out... Dans le forum Software (Archive)	il y a 10 years
	Sorry, I figured out what I did wrong. The conflict was my o... Dans le forum Software (Archive)	il y a 10 years
	Just tried a Verify of my changes and received this error me... Dans le forum Software (Archive)	il y a 10 years
	Just realized what that was for. It came from the Prusa3D si... Dans le forum Software (Archive)	il y a 10 years
	Agreed. One more quick question... Where do I place the ma... Dans le forum Software (Archive)	il y a 10 years
	Okay, that clears it up some. Still trying to figure out ho... Dans le forum Software (Archive)	il y a 10 years
	I have received my inductive sensor and am in the process of... Dans le forum Software (Archive)	il y a 10 years
	I downloaded and printed this fine. I would think it is a s... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Not sure where you are located, but I bought a spare sheet f... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	@ken Thanks for diving head-first into this. Your results ... Dans le forum Software (Archive)	il y a 10 years
	@Ken Thanks for the info. What voltage does the servo need... Dans le forum Software (Archive)	il y a 10 years
	@Ken I'm interested in how the prints turn out. Also, if it... Dans le forum Software (Archive)	il y a 10 years
	@Nathan I have looked at the printinz one as well as this o... Dans le forum Software (Archive)	il y a 10 years
	I've been trying to find a good source for an aluminum build... Dans le forum Software (Archive)	il y a 10 years
	Nathan, Thanks for responding to my questions. You are c... Dans le forum Software (Archive)	il y a 10 years

Page 35 / 37 Précédent Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.3 K Messages

11 En-ligne

76.2 K Membres

Le dernier des messages: My first TPU - how to interpret speed settings Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé