richard.l – Aktivita – Prusa3D Forum

Notifications

Clear all

richard.l

Skupina: Moderátor

Přidal se: 2015/10/29

Název: Member Moderator

	Hi Peter, I was just grabbing at straws. It still sounds li... In forum Others (Archive)	před 10 years
	If you do a preheat for PLA what does the bed heat to? I'm w... In forum Others (Archive)	před 10 years
	Adam, There shouldn't be a 2 ohm difference between the boa... In forum Others (Archive)	před 10 years
	Christian, There is nothing stopping you from using your cu... In forum Others (Archive)	před 10 years
	Unfortunately I have noticed this as well. At some point the... In forum Software (Archive)	před 10 years
	Peter No upgrade yet. I would assume they will start shippi... In forum Software (Archive)	před 10 years
	Keri, Just from looking at the video it would seem your z-p... In forum Others (Archive)	před 10 years
	Andrew, To expand a little more on Peter's suggestion I wou... In forum Prusa i3 kit (Archive)	před 10 years
	Excellent! Been looking frequently for them to be posted. I... In forum Software (Archive)	před 10 years
	Extruder fan should always be on. The part fan needs to be o... In forum Prusa i3 kit (Archive)	před 10 years
	Absolutely! Even ordered the upgrade. I have used my Prusa ... In forum Prusa i3 kit (Archive)	před 10 years
	PETG is notorious for being stringy. It will collect on the ... In forum Print tips (Archive)	před 10 years
	Ordering mine this weekend. I doubt the heatup time will be... In forum Prusa i3 kit (Archive)	před 10 years
	@josefprusa When will the raw 3.0 firmware files be availab... In forum Software (Archive)	před 10 years
	Nigel The only ones that had knowledge of a release date wo... In forum Prusa i3 kit (Archive)	před 10 years
	Peter Many thanks for the links. I can say I never would ha... In forum Improvements (Archive)	před 10 years
	Disappointment In forum Prusa i3 kit (Archive)	před 10 years
	Peter While I try to refrain from getting in these little s... In forum Improvements (Archive)	před 10 years
	I am reasonably confident of the temperatures, but note that... In forum Prusa i3 kit (Archive)	před 10 years
	Instead of chopping pieces off the frame, why not use someth... In forum Improvements (Archive)	před 10 years

Stránka 32 / 37 Předchozí Další

Fórum Statistiky

595 Fóra

69.4 K Témata

485.9 K Příspěvky

15 Online

79.1 K Uživatelé

Poslední Příspěvek: Quick tip: Wipe tower failure fix Nový Uživatel: João de Brito Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed