richard.l – Activité – Prusa3D Forum

Notifications

Clear all

richard.l

Groupe: Modérateur

A(ont) rejoint: 2015/10/29

Titre: Membre Moderator

	No retraction and print slooooow. Dans le forum Print tips (Archive)	il y a 9 years
	It's got to be something with your settings or the stl. Here... Dans le forum Print tips (Archive)	il y a 9 years
	While this may sound like a good idea I'm not sure it could ... Dans le forum Others (Archive)	il y a 9 years
	Nice! Did you do any filling or sanding before painting? Dans le forum Awesome prints (Hall Of Fame)	il y a 9 years
	The cooling settings in S3D are based on percentage so the h... Dans le forum Others (Archive)	il y a 9 years
	Ha, well, relatively speaking anyway. I've never done PID tu... Dans le forum Others (Archive)	il y a 9 years
	I personally am going to be getting a tungsten nozzle. It's... Dans le forum Others (Archive)	il y a 9 years
	The red stripe on the cables do not go to the 1 pin on the R... Dans le forum Others (Archive)	il y a 9 years
	Flip the cables on the board. For some unexplained reason th... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I had seen that, but thought it was just a -per file- statis... Dans le forum Software (Archive)	il y a 9 years
	I'm assuming you meant .05mm. You need more infill or many m... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Here's the plugin you want.. Dans le forum Software (Archive)	il y a 9 years
	Unfortunately I'm going to have to find a new place to mount... Dans le forum Others (Archive)	il y a 9 years
	The socks are designed to be used with the heater block in t... Dans le forum Others (Archive)	il y a 9 years
	I'm really glad you took what I said in the manner it was in... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I really don't want this to sound like I'm being condescendi... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Peter, Have you ever noticed that the _printer.ini file use... Dans le forum Print tips (Archive)	il y a 9 years
	Luc, This seems to be the most logical expectation based on... Dans le forum Others (Archive)	il y a 9 years
	He mentioned in his Twitter feed, I believe, that it would b... Dans le forum Others (Archive)	il y a 9 years
	I use 195 for most of my Hatchbox filament. Bed temp is the ... Dans le forum Print tips (Archive)	il y a 9 years

Page 26 / 37 Précédent Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.3 K Messages

11 En-ligne

76.1 K Membres

Le dernier des messages: Performance difference? Pi0 to Pi4 upgrade, USB or GPIO/Einsy interface Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé