Prusa3D Forum

Notifications

Clear all

richard.c16

Groupe: Enregistré

A(ont) rejoint: 2017/04/20

Active Member

	my print finished and it actually was alot better than i tho... Dans le forum Hardware, firmware and software help	il y a 6 years
	Im doing a super detailed print atm and i notice that its ma... Dans le forum Hardware, firmware and software help	il y a 6 years
	Discolored on print bed Dans le forum Hardware, firmware and software help	il y a 6 years
	I editied my gcode by putting mesh leveling before the prehe... Dans le forum Hardware, firmware and software help	il y a 6 years
	Did you include the instruction to home the extruder positio... Dans le forum Hardware, firmware and software help	il y a 6 years
	I editied my gcode by putting mesh leveling before the prehe... Dans le forum Hardware, firmware and software help	il y a 6 years
	how to stop extruder extruding filament when preheating Dans le forum Hardware, firmware and software help	il y a 6 years
	Thanks for the reply so after i tried printing with pla and ... Dans le forum Print tips (Archive)	il y a 8 years
	UPDATE: Now pla wont even work it start printing above the b... Dans le forum Print tips (Archive)	il y a 8 years
	I can not get abs or hips to print FRUSTRATING Dans le forum Print tips (Archive)	il y a 8 years

Statistiques du forum

559 Forums

63 K Sujets

443.2 K Messages

22 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé