Notifications
Clear all
rhornsby
Grupa: Zarejestrowany
Dołączył: 2026/02/15
Active Member
1
| The inset image was the key. Finally got a print. I don't kn... | 2 months temu | |
| Thanks for the hint about the calibration. That's good to kn... | 2 months temu | |
| Did you loosen all six M3 screws (3*2) which old the three t... | 2 months temu | |
| Yep, I did. The plate moved smoothly and without any binding... | 2 months temu | |
| Another thing to try is to remove the screws holding the T-n... | 2 months temu | |
| Thanks for the reply. The screws appear to turn freely, exce... | 2 months temu | |
| Thanks for the replies. The nozzle was out too far, but now ... | 2 months temu | |
| You must be kidding us, right? Well, if you want to destroy ... | 2 months temu | |
| first print trash; extruder "clicking" noises | 2 months temu | |
| Thank for your reply. You were exactly correct. I had the sm... | 2 months temu | |
| assembly: cannot lock idler arm/swivel | 2 months temu |