Prusa3D Forum

Notifications

Clear all

rhornsby

Group: Registered

Joined: 2026/02/15

Active Member

	The inset image was the key. Finally got a print. I don't kn... In forum Assembly and first prints troubleshooting	5 days ago
	Thanks for the hint about the calibration. That's good to kn... In forum Assembly and first prints troubleshooting	5 days ago
	Did you loosen all six M3 screws (3*2) which old the three t... In forum Assembly and first prints troubleshooting	6 days ago
	Yep, I did. The plate moved smoothly and without any binding... In forum Assembly and first prints troubleshooting	2 weeks ago
	Another thing to try is to remove the screws holding the T-n... In forum Assembly and first prints troubleshooting	2 weeks ago
	Thanks for the reply. The screws appear to turn freely, exce... In forum Assembly and first prints troubleshooting	2 weeks ago
	Thanks for the replies. The nozzle was out too far, but now ... In forum Assembly and first prints troubleshooting	2 weeks ago
	You must be kidding us, right? Well, if you want to destroy ... In forum Assembly and first prints troubleshooting	3 weeks ago
	first print trash; extruder "clicking" noises In forum Assembly and first prints troubleshooting	3 weeks ago
	Thank for your reply. You were exactly correct. I had the sm... In forum Assembly and first prints troubleshooting	3 weeks ago
	assembly: cannot lock idler arm/swivel In forum Assembly and first prints troubleshooting	3 weeks ago

Forum Statistics

598 Forums

70.8 K Topics

495.9 K Posts

11 Online

82.1 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed