Notifications
Clear all
RH_Dreambox
RH_Dreambox
Group: Registered
Joined: 2017/10/23
Prominent Member
2
Nice to read about a test with real heavy support 😀 Too b...

In forum Others (Archive)

7 years ago
Here is a simple male ball joint that I printed a little whi...

In forum Others (Archive)

7 years ago
Live Z calibration is being performed the same as it was bef...

In forum Others (Archive)

7 years ago
Borrow a little nail polish and paint over the scratches.

In forum Others (Archive)

7 years ago
If all of these issues occurred after the upgrade, there mig...

In forum Others (Archive)

7 years ago
I understand why you missed this. You are in a hurry to get ...

In forum Others (Archive)

7 years ago
Your spool holder is incorrectly mounted. The X unit collide...

In forum Others (Archive)

7 years ago
I have not yet written something with rasied letters yet, bu...

In forum Others (Archive)

7 years ago
At this point I am really wondering about some way to replac...

In forum Others (Archive)

7 years ago
Zaz is right, the probe measures the distance down to the sh...

In forum Others (Archive)

7 years ago
I ask of pure curiosity. Why do you want to turn off Z-lift?...

In forum Others (Archive)

7 years ago
If the nozzle scratches in the bed during calibration, the P...

In forum Others (Archive)

7 years ago
Okay starting in the top left we have 600, top right 650, mi...

In forum Others (Archive)

7 years ago
No you do not need to remove the frame, just Z-axis-top left...

In forum Others (Archive)

7 years ago
Try to loosen the center screw for the X (and Y) end pulley....

In forum Others (Archive)

7 years ago
I used 0.3 layer height Layer height 0.3 mm is not a stand...

In forum Others (Archive)

7 years ago
I have tested many FFF profiles on the forum and this worked...

In forum Others (Archive)

7 years ago
I run PrusaPrint on Raspberry Pi3 (USB cable) without any is...

In forum Others (Archive)

7 years ago
Spartacus' statement may have been a bit harsh but it was ri...

In forum General discussion, announcements and releases

7 years ago
If the nozzle scratches on the bed (with or without steel sh...

In forum Others (Archive)

7 years ago
Page 34 / 42
Share: