RH_Dreambox – Activité

Notifications

Clear all

RH_Dreambox

Groupe: Enregistré

A(ont) rejoint: 2017/10/23

Prominent Member

	Nice to read about a test with real heavy support 😀 Too b... Dans le forum Others (Archive)	il y a 7 years
	Here is a simple male ball joint that I printed a little whi... Dans le forum Others (Archive)	il y a 7 years
	Live Z calibration is being performed the same as it was bef... Dans le forum Others (Archive)	il y a 7 years
	Borrow a little nail polish and paint over the scratches. Dans le forum Others (Archive)	il y a 7 years
	If all of these issues occurred after the upgrade, there mig... Dans le forum Others (Archive)	il y a 7 years
	I understand why you missed this. You are in a hurry to get ... Dans le forum Others (Archive)	il y a 7 years
	Your spool holder is incorrectly mounted. The X unit collide... Dans le forum Others (Archive)	il y a 7 years
	I have not yet written something with rasied letters yet, bu... Dans le forum Others (Archive)	il y a 7 years
	At this point I am really wondering about some way to replac... Dans le forum Others (Archive)	il y a 7 years
	Zaz is right, the probe measures the distance down to the sh... Dans le forum Others (Archive)	il y a 7 years
	I ask of pure curiosity. Why do you want to turn off Z-lift?... Dans le forum Others (Archive)	il y a 7 years
	If the nozzle scratches in the bed during calibration, the P... Dans le forum Others (Archive)	il y a 7 years
	Okay starting in the top left we have 600, top right 650, mi... Dans le forum Others (Archive)	il y a 7 years
	No you do not need to remove the frame, just Z-axis-top left... Dans le forum Others (Archive)	il y a 7 years
	Try to loosen the center screw for the X (and Y) end pulley.... Dans le forum Others (Archive)	il y a 7 years
	I used 0.3 layer height Layer height 0.3 mm is not a stand... Dans le forum Others (Archive)	il y a 7 years
	I have tested many FFF profiles on the forum and this worked... Dans le forum Others (Archive)	il y a 7 years
	I run PrusaPrint on Raspberry Pi3 (USB cable) without any is... Dans le forum Others (Archive)	il y a 7 years
	Spartacus' statement may have been a bit harsh but it was ri... Dans le forum General discussion, announcements and releases	il y a 7 years
	If the nozzle scratches on the bed (with or without steel sh... Dans le forum Others (Archive)	il y a 7 years

Page 34 / 42 Précédent Suivant

Statistiques du forum

559 Forums

62.5 K Sujets

441.1 K Messages

19 En-ligne

66.7 K Membres

Le dernier des messages: Change size in one dimension only Notre nouveau membre: Kyle Cornelius Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé