Notifications
Clear all
REMLURELMI
Skupina: Registrovaný
Přidal se: 2024/09/21
Active Member
1
|
I ended up replacing the nozzle - it's been about two weeks ... In forum Hardware, firmware and software help |
před 3 months | |
| To close the loop on this, I ended up replacing the nozzle, ... | před 3 months | |
|
I'm having this issue as well: In forum Hardware, firmware and software help |
před 3 months | |
| I did a few more cold pulls with no change in operation, and... | před 4 months | |
| First few prints were perfect, now "stuck filament detected"... | před 4 months |