Prusa3D Forum

Notifications

Clear all

redherring9

Groupe: Enregistré

A(ont) rejoint: 2019/03/01

Active Member

	Thanks these settings were all from before the tube reset...... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks @gnat @vojtech-p6 - you've both confirmed this is wha... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Had to replace PTFE, now going backwards, print not sticking... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks Joan I hadn't realised the collar was called a COLLET... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	thanks john.h68 I am pretty pleased with how my Z-calibratio... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	MK3S - where can I find a ptfe "collar"? Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	THANKS for the guidance. I think I am making success. I hav... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	THANKS! I took the defaults and lowered them. so the Height ... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Newbie: Prints GOOD, except first 3-4 layers?? Dans le forum Assembly and first prints troubleshooting	il y a 6 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

20 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé