Čeština
Fóra
Uživatelé
RCNet
Aktivita
 
Notifications
Clear all
RCNet
RCNet
Skupina: Registrovaný
Přidal se: 2015/11/30
Trusted Member
3
Profile Aktivita
Really nice Sascha!! I was going to do something similar fo...

In forum Awesome prints (Hall Of Fame)

 před 10 years
I had it happen once to me as well this weekend. The printer...

In forum Prusa i3 kit (Archive)

 před 10 years
Thanks Josef!! 😀

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Ben, Thanks! I'm still working with nothing but the gre...

In forum Awesome prints (Hall Of Fame)

 před 10 years
Not worthy of the Hall of Fame....

In forum Awesome prints (Hall Of Fame)

 před 10 years
Thanks endaf & Peter, I looked at the schematics a litt...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Peter, I've been printing primarily from SD card since I...

In forum Prusa i3 kit (Archive)

 před 10 years
I've had some success determining what is happening when the...

In forum Prusa i3 kit (Archive)

 před 10 years
When I was researching enclosure ideas, I found a nifty encl...

In forum Prusa i3 kit (Archive)

 před 10 years
I have almost no experience with 3D printing so far, but wha...

In forum Prusa i3 kit (Archive)

 před 10 years
Hi Sandor, It looks like your ribbon cables might be on bac...

In forum Prusa i3 kit (Archive)

 před 10 years
It took all day, but I was able to capture the issue. I di...

In forum Prusa i3 kit (Archive)

 před 10 years
Jason, I have done it with Slic3r. You just add additional ...

In forum Print tips (Archive)

 před 10 years
Hi Josef, I updated back to FW 2.2.1 and will keep my came...

In forum Prusa i3 kit (Archive)

 před 10 years
I found leveling the bed a bit fiddly as well until I found ...

In forum Prusa i3 kit (Archive)

 před 10 years
Just an FYI/observation. Since installing the 2.2.1 firmwar...

In forum Prusa i3 kit (Archive)

 před 10 years
Stránka 3 / 3
Share: