Prusa3D Forum

Notifications

Clear all

Ratman

Skupina: Registrovaný

Přidal se: 2022/12/08

Active Member

	The washers are underneath the 6x6x3 spacers. So the bed sit... In forum Assembly and first prints troubleshooting	před 3 years
	I tried the bolt upside down, but the nut is too big and doe... In forum Assembly and first prints troubleshooting	před 3 years
	Thank you for checking, i guess it's just how it isI think 0... In forum Assembly and first prints troubleshooting	před 3 years
	Y-axis bearing bolt touching bed from below In forum Assembly and first prints troubleshooting	před 3 years
	I had the same problem with mine. It was caused by the cable... In forum Assembly and first prints troubleshooting	před 3 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.9 K Příspěvky

11 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed