|
I though about that, but moving full layers would be too bul... Im Forum Hardware, firmware and software help |
Vor 6 years |
|
Is there a print timeline rewind/advance option? Im Forum Hardware, firmware and software help |
Vor 6 years |
|
This is the official statement from PR:
This is why I men... Im Forum General discussion, announcements and releases |
Vor 6 years |
|
Just bringing this back from the dead a bit.
Did you guys s... Im Forum General discussion, announcements and releases |
Vor 6 years |
|
I got to the step of assembling the two tops and came to the... Im Forum General discussion, announcements and releases |
Vor 6 years |
|
Here is the print.
I am on the latest 3.21 firmware and lat... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Hello
I am not sure, if its cooling problem or not. Are you... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
From the prints I was getting, I believe that the stock prus... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
I think that everyone should remember there are 2 separate i... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
I've been noticing the the back of the printer does not get ... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
I noted this before on another thread, but not sure if anyon... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
What is odd, is that the Trinamic drivers are supposedly mad... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Very good find!
I'd be curious to know what option the prus... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
or since they are still there at higher power, if software r... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
So doesn't this point to the extruder needing to be geared a... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
The filament always seems to get a hardened glob inside that... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
I had not seen that, but it does look similar.
This one I m... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 7 years |
|
Thought this might be a fun picture for reference. The shaft... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
Thanks.
I printed them up for another mod but I think I'll ... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 7 years |
|
some more pics Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 7 years |
