|
It Sems, that Internet Streaming also works with FW3.1.3 In forum Buddy3D |
5 days temu |
|
Yes, can confirm the manual update to 3.1.3 was working fine... In forum Buddy3D |
6 days temu |
|
Hi, normally If a New Version is Released, This is written d... In forum Buddy3D |
2 months temu |
|
My fingers were faster than my brain, I apologize. The solu... In forum OpenPrintTag |
2 months temu |
|
The Solution under had worked for me In forum OpenPrintTag |
2 months temu |
|
I was only scanning the QR-code from a prusament spool, then... In forum OpenPrintTag |
3 months temu |
|
I had the Issue on the Core One cam with the new Firmware 3.... In forum Buddy3D |
3 months temu |
|
Ok, found it! my fault. I thought the sd-card was formatted ... In forum Buddy3D |
3 months temu |
|
Sorry for the late reply,I've tried the downgrade to 3.1.0 w... In forum Buddy3D |
3 months temu |
|
@ssmith
yes i‘m using the iOS
Version: 1.13.3+287
tes... In forum OpenPrintTag |
3 months temu |
|
Yes, cloning data from the QR of a Spool Prusament onto a bl... In forum OpenPrintTag |
3 months temu |
|
@Pomidoor: not a joke at all, with FW 3.1.1 the Cam was fine... In forum Buddy3D |
3 months temu |
|
The Quality of the WiFi Signal is @100%, because the access ... In forum Buddy3D |
3 months temu |
|
Buddy Cam Core One Wifi connection failed after update to FW... In forum Buddy3D |
3 months temu |
|
I also report this issue, when sending a print file to conne... In forum Bugs & Errors |
4 months temu |
|
I Think something is in preparation.in Connect there is a li... In forum General discussion & User Experience & Ideas |
7 months temu |
|
Yes, i agree! a Widget would be really Nice, also the implem... In forum General discussion, announcements and releases |
10 months temu |
|
Hi, The same here, sometimes I have a connection, than tls- ... In forum Bugs & Errors |
10 months temu |
|
My Kit arrived yesterday and as many before, one part is sha... In forum General discussion, announcements and releases |
10 months temu |
|
Ok, Shipping from batch One. Ordered at 31.1. the Mail for O... In forum General discussion, announcements and releases |
11 months temu |
