|
It Sems, that Internet Streaming also works with FW3.1.3 En el foro Buddy3D |
hace 5 days |
|
Yes, can confirm the manual update to 3.1.3 was working fine... En el foro Buddy3D |
hace 6 days |
|
Hi, normally If a New Version is Released, This is written d... En el foro Buddy3D |
hace 2 months |
|
My fingers were faster than my brain, I apologize. The solu... En el foro OpenPrintTag |
hace 2 months |
|
The Solution under had worked for me En el foro OpenPrintTag |
hace 2 months |
|
I was only scanning the QR-code from a prusament spool, then... En el foro OpenPrintTag |
hace 3 months |
|
I had the Issue on the Core One cam with the new Firmware 3.... En el foro Buddy3D |
hace 3 months |
|
Ok, found it! my fault. I thought the sd-card was formatted ... En el foro Buddy3D |
hace 3 months |
|
Sorry for the late reply,I've tried the downgrade to 3.1.0 w... En el foro Buddy3D |
hace 3 months |
|
@ssmith
yes i‘m using the iOS
Version: 1.13.3+287
tes... En el foro OpenPrintTag |
hace 3 months |
|
Yes, cloning data from the QR of a Spool Prusament onto a bl... En el foro OpenPrintTag |
hace 3 months |
|
@Pomidoor: not a joke at all, with FW 3.1.1 the Cam was fine... En el foro Buddy3D |
hace 3 months |
|
The Quality of the WiFi Signal is @100%, because the access ... En el foro Buddy3D |
hace 3 months |
|
Buddy Cam Core One Wifi connection failed after update to FW... En el foro Buddy3D |
hace 3 months |
|
I also report this issue, when sending a print file to conne... En el foro Bugs & Errors |
hace 4 months |
|
I Think something is in preparation.in Connect there is a li... En el foro General discussion & User Experience & Ideas |
hace 7 months |
|
Yes, i agree! a Widget would be really Nice, also the implem... En el foro General discussion, announcements and releases |
hace 10 months |
|
Hi, The same here, sometimes I have a connection, than tls- ... En el foro Bugs & Errors |
hace 10 months |
|
My Kit arrived yesterday and as many before, one part is sha... En el foro General discussion, announcements and releases |
hace 10 months |
|
Ok, Shipping from batch One. Ordered at 31.1. the Mail for O... En el foro General discussion, announcements and releases |
hace 11 months |
