Notifications
Clear all
ralf.s7
Groupe: Enregistré
A(ont) rejoint: 2018/03/31
Active Member
1
|
I am using
Capricorn XS PTFE
as replacement and it works f... Dans le forum User mods - OctoPrint, enclosures, nozzles, ... |
il y a 6 years | |
|
Thank you very much, just installed and tested.
It works fin... Dans le forum General discussion, announcements and releases |
il y a 6 years | |
|
Adjusting the "K"-value did the job:
shown result was reache... Dans le forum How do I print this? (Printing help) |
il y a 7 years | |
|
Thank you Curtis,
Will work through the Infos.
Regards
Ralf Dans le forum How do I print this? (Printing help) |
il y a 7 years | |
|
vertical edges are round Dans le forum How do I print this? (Printing help) |
il y a 7 years |