Français
Forums
Membres
Racenviper
Activité
 
Notifications
Clear all
Racenviper
Racenviper
Groupe: Enregistré
A(ont) rejoint: 2018/01/23
Eminent Member
2
Profil Activité
Had the same thoughts also, the blob is behind the extruder ...

Dans le forum Hardware, firmware and software help

 il y a 2 years
Blob of Death, Standard Nozzle Adapter

Dans le forum Hardware, firmware and software help

 il y a 2 years
esteps

Dans le forum Hardware, firmware and software help

 il y a 2 years
This is the Prusa Article:/p> Use-defined LED statuses LEDs ...

Dans le forum Hardware, firmware and software help

 il y a 2 years
First half shows filament will load properly The last minut...

Dans le forum Assembly and first prints troubleshooting

 il y a 6 years
Will not load 2nd filament during print

Dans le forum Assembly and first prints troubleshooting

 il y a 6 years
This was a tough fix. Prusa first sent a filament sensor, th...

Dans le forum Hardware, firmware and software help

 il y a 7 years
I did contact Prusa chat, they are sending a replacement PIN...

Dans le forum Hardware, firmware and software help

 il y a 7 years
I did a Factory Reset and the printer calibration fails at t...

Dans le forum Hardware, firmware and software help

 il y a 7 years
A factory reset is hold the rotating knob and power on

Dans le forum Hardware, firmware and software help

 il y a 7 years
3.2.1 576 Downloaded from the Prusa site

Dans le forum Hardware, firmware and software help

 il y a 7 years
I can move the z axis up and down to the point where the pri...

Dans le forum Hardware, firmware and software help

 il y a 7 years
Joan, I dont know the "Zend stop" can not find it in the m...

Dans le forum Hardware, firmware and software help

 il y a 7 years
Stuck at the top of the Z Axis

Dans le forum Hardware, firmware and software help

 il y a 7 years
Page 2 / 2
Partager :