Čeština
Fóra
Uživatelé
Racenviper
Aktivita
 
Notifications
Clear all
Racenviper
Racenviper
Skupina: Registrovaný
Přidal se: 2018/01/23
Eminent Member
2
Profile Aktivita
Had the same thoughts also, the blob is behind the extruder ...

In forum Hardware, firmware and software help

 před 2 years
Blob of Death, Standard Nozzle Adapter

In forum Hardware, firmware and software help

 před 2 years
esteps

In forum Hardware, firmware and software help

 před 2 years
This is the Prusa Article:/p> Use-defined LED statuses LEDs ...

In forum Hardware, firmware and software help

 před 2 years
First half shows filament will load properly The last minut...

In forum Assembly and first prints troubleshooting

 před 7 years
Will not load 2nd filament during print

In forum Assembly and first prints troubleshooting

 před 7 years
This was a tough fix. Prusa first sent a filament sensor, th...

In forum Hardware, firmware and software help

 před 7 years
I did contact Prusa chat, they are sending a replacement PIN...

In forum Hardware, firmware and software help

 před 7 years
I did a Factory Reset and the printer calibration fails at t...

In forum Hardware, firmware and software help

 před 7 years
A factory reset is hold the rotating knob and power on

In forum Hardware, firmware and software help

 před 7 years
3.2.1 576 Downloaded from the Prusa site

In forum Hardware, firmware and software help

 před 7 years
I can move the z axis up and down to the point where the pri...

In forum Hardware, firmware and software help

 před 7 years
Joan, I dont know the "Zend stop" can not find it in the m...

In forum Hardware, firmware and software help

 před 7 years
Stuck at the top of the Z Axis

In forum Hardware, firmware and software help

 před 7 years
Stránka 2 / 2
Share: