Notifications
Clear all
Pylot818
Skupina: Registrovaný
Přidal se: 2019/03/09
Active Member
1
| What should I select if I would like to print TPU/Flexfill m... | před 6 years | |
|
Thank you, but in my first post I mentioned how I had disabl... In forum How do I print this? (Printing help) |
před 6 years | |
|
...after some cleaning... at least it works and it’ll do it’... In forum How do I print this? (Printing help) |
před 6 years | |
|
First TPU prints... not 100% happy yet In forum How do I print this? (Printing help) |
před 6 years | |
|
Thanks for the reply! I did notice the subtle bubbling went... In forum Hardware, firmware and software help |
před 6 years | |
|
Print bed marks after prints. Failing print bed? In forum Hardware, firmware and software help |
před 6 years | |
| Thanks! That Dino looks great! | před 6 years | |
| This ended up being the print after setting the Z height to ... | před 6 years | |
| That dang line is SO tiny that it’s difficult to read what t... | před 6 years | |
| I cancelled the second Rex print (which seemed to be going b... | před 6 years | |
| Rex | před 6 years | |
| I3 MK3S First prints (my first 3D printer) | před 6 years |