Prusa3D Forum

Notifications

Clear all

Print-Crafter

Groupe: Enregistré

A(ont) rejoint: 2025/04/17

Active Member

	Thanks for the detailed explanation. I’m running 7 Prusa X... Dans le forum How do I print this? (Printing help)	il y a 1 month
	increasing chamber temperature for ASA Dans le forum How do I print this? (Printing help)	il y a 1 month
	okay so i had for months problems, i was trying and trying n... Dans le forum How do I print this? (Printing help)	il y a 9 months
	0.25 nozzle clogging Dans le forum How do I print this? (Printing help)	il y a 11 months
	Yes, I already tried printing at 190 °C, but the nozzle clog... Dans le forum How do I print this? (Printing help)	il y a 11 months
	Thanks again for the suggestions! I had all fans running at ... Dans le forum How do I print this? (Printing help)	il y a 11 months
	I printed with the enclosure open, using 215 °C on the nozzl... Dans le forum How do I print this? (Printing help)	il y a 11 months
	I’m using standard PLA from Prusa – no glitter, no silk, not... Dans le forum How do I print this? (Printing help)	il y a 11 months
	Clogging issues with 0.25 mm nozzle – clicking and filament ... Dans le forum How do I print this? (Printing help)	il y a 11 months

Statistiques du forum

598 Forums

70.8 K Sujets

496.4 K Messages

16 En-ligne

82.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé