Čeština
Fóra
Uživatelé
PPRRUUSSAA
Aktivita
 
Notifications
Clear all
PPRRUUSSAA
PPRRUUSSAA
Skupina: Registrovaný
Přidal se: 2019/10/12
Trusted Member
3
Profile Aktivita
THX, with the new parameters, the prints are looking great a...

In forum Hardware, firmware and software help

 před 5 years
I will check everything. The File from neophyl is looking be...

In forum Hardware, firmware and software help

 před 5 years
@neophyl hi, the filament is prusament. The one they sent wi...

In forum Hardware, firmware and software help

 před 5 years
@ tim, my "Famed Member" is the file I attached in my first ...

In forum Hardware, firmware and software help

 před 5 years
and after restarting the print, again and again underextrusi...

In forum Hardware, firmware and software help

 před 5 years
underextrusion / extruder or slicer problems?

In forum Hardware, firmware and software help

 před 5 years
Look at this workflow: ready to save on SD-card (SD-card de...

In forum General discussion, announcements and releases

 před 5 years
@neophyl Aaaahhhhhhhh, the suppor blocker had to intersect w...

In forum How do I print this? (Printing help)

 před 5 years
@ lichtjaeger, normally the blockers are insight. I have cha...

In forum How do I print this? (Printing help)

 před 5 years
here is the reduced problem ... in the 3mf file. TestBody Ob...

In forum How do I print this? (Printing help)

 před 5 years
My supportblockers do not work

In forum How do I print this? (Printing help)

 před 5 years
Hi, I am missing the eject function after writing to an SD-c...

In forum General discussion, announcements and releases

 před 5 years
Geräusch: quietschendes Pastik itschi/Itschi/itschi bei neu ...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

 před 5 years
Stránka 4 / 4
Share: