Prusa3D Forum

Notifications

Clear all

Poul-Erik Hagemann

Groupe: Enregistré

A(ont) rejoint: 2024/11/20

Active Member

	Petg probs Dans le forum How do I print this? (Printing help)	il y a 3 months
	Thx a lot. I'll give it a try with a bit higher temp. Dans le forum Hardware, firmware and software help	il y a 8 months
	One more try with the zip 83591770-clamp.zip Dans le forum Hardware, firmware and software help	il y a 8 months
	Yes, I also find it a bit odd. Regards Poul Erik Dans le forum Hardware, firmware and software help	il y a 8 months
	It is, but seems like it does'nt get accepted when pressing ... Dans le forum Hardware, firmware and software help	il y a 8 months
	Ohh, forgot the file..sry. Here it is. (Hope it works, hav... Dans le forum Hardware, firmware and software help	il y a 8 months
	First layer is looking fine Dans le forum Hardware, firmware and software help	il y a 8 months
	Thx, i'll try to get the pictures uploaded Dans le forum Hardware, firmware and software help	il y a 8 months
	PETG problems Dans le forum Hardware, firmware and software help	il y a 8 months
	Internal memory probs. Dans le forum Hardware, firmware and software help	il y a 10 months

Statistiques du forum

585 Forums

68.2 K Sujets

478 K Messages

11 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé