Notifications
Clear all
pop aruaru
Groupe: Enregistré
A(ont) rejoint: 2025/03/26
Active Member
1
|
It's hard to understand the changes, but I'm glad the proble... Dans le forum PrusaSlicer |
il y a 10 months | |
|
I set the Multiple Extruders setting to #3, but the default ... Dans le forum PrusaSlicer |
il y a 10 months | |
|
The color of the slicer is the same as extruder#1, but I thi... Dans le forum PrusaSlicer |
il y a 10 months | |
|
Thanks Dans le forum PrusaSlicer |
il y a 10 months | |
|
Thanks.
But The advice is not what I need. I only need a w... Dans le forum PrusaSlicer |
il y a 10 months | |
|
How to assign default extruder? Dans le forum PrusaSlicer |
il y a 10 months | |
|
The height was insufficient, so I attached a bracket to the ... Dans le forum Buddy3D |
il y a 10 months |