Aktivität
 
Benachrichtigungen
Alles löschen
plc268
plc268
Gruppe: Registriert
Beigetreten: 2016/11/20
Active Member
1
I figured it out. I had "only infill where needed" selected,...

Im Forum General discussion, announcements and releases

Vor 6 years
I think I found a bug in Slic3r PE 1.41.1 that wasn't presen...

Im Forum General discussion, announcements and releases

Vor 6 years
Seems like the only purpose of Limonene is to remove the adh...

Im Forum General discussion, announcements and releases

Vor 6 years
So you are suggesting that my solution of hoisting the print...

Im Forum Others (Archive)

Vor 7 years
Definitely a bed level issue, and I have the same problem. M...

Im Forum Others (Archive)

Vor 7 years
Run your gcodes through Repetier Host. It is by far the most...

Im Forum Others (Archive)

Vor 7 years
I'm just going to leave the filament sensor off. I haven't h...

Im Forum Others (Archive)

Vor 7 years
I too plan using Loctite Blue on my MK3 when it arrives. Lat...

Im Forum Others (Archive)

Vor 7 years
I got the Label Created email today. Mine was created on t...

Im Forum General discussion, announcements and releases

Vor 7 years
Just got my notice. Mail came just after 8am Prague time. ...

Im Forum General discussion, announcements and releases

Vor 7 years
I haven't received any notification at all from prusa. Order...

Im Forum General discussion, announcements and releases

Vor 7 years
Managed to break several HSS drill bits before I finally fou...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
I have the same problem. Holes had no thread, and the screws...

Im Forum Prusa i3 kit (Archive)

Vor 8 years
I ordered my kit on November 20, and hasn't shipped yet. Hop...

Im Forum General discussion, announcements and releases

Vor 8 years
Teilen: