Activity
 
Notifications
Clear all
plc268
plc268
Group: Registered
Joined: 2016/11/20
Active Member
1
I figured it out. I had "only infill where needed" selected,...

In forum General discussion, announcements and releases

6 years ago
I think I found a bug in Slic3r PE 1.41.1 that wasn't presen...

In forum General discussion, announcements and releases

6 years ago
Seems like the only purpose of Limonene is to remove the adh...

In forum General discussion, announcements and releases

7 years ago
So you are suggesting that my solution of hoisting the print...

In forum Others (Archive)

7 years ago
Definitely a bed level issue, and I have the same problem. M...

In forum Others (Archive)

7 years ago
Run your gcodes through Repetier Host. It is by far the most...

In forum Others (Archive)

7 years ago
I'm just going to leave the filament sensor off. I haven't h...

In forum Others (Archive)

7 years ago
I too plan using Loctite Blue on my MK3 when it arrives. Lat...

In forum Others (Archive)

7 years ago
I got the Label Created email today. Mine was created on t...

In forum General discussion, announcements and releases

7 years ago
Just got my notice. Mail came just after 8am Prague time. ...

In forum General discussion, announcements and releases

7 years ago
I haven't received any notification at all from prusa. Order...

In forum General discussion, announcements and releases

7 years ago
Managed to break several HSS drill bits before I finally fou...

In forum Prusa i3 kit (Archive)

8 years ago
I have the same problem. Holes had no thread, and the screws...

In forum Prusa i3 kit (Archive)

8 years ago
I ordered my kit on November 20, and hasn't shipped yet. Hop...

In forum General discussion, announcements and releases

8 years ago
Share: