PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Yes. You certainly need the rear extruder and cable support... Dans le forum Others (Archive)	il y a 8 years
	Was the PTFE tube too long or was it not seated correctly in... Dans le forum Others (Archive)	il y a 8 years
	In Slic3r, I have now chosen "Prusa PLA 1.75 mm (modified)" ... Dans le forum Others (Archive)	il y a 8 years
	Not _obvious_ . Totally agree on that.It is the logical th... Dans le forum Others (Archive)	il y a 8 years
	Thomas SORRY 🙄 But ir was all to do with the extrud... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Jeff Did you see the purge line? Doesn't look right to me:... Dans le forum Others (Archive)	il y a 8 years
	you're right Peter, but do you believe that this is the caus... Dans le forum Others (Archive)	il y a 8 years
	No changing the extrusion multiplier will only reduce the vo... Dans le forum Others (Archive)	il y a 8 years
	OK, there's something not right in your GCode settings. App... Dans le forum Others (Archive)	il y a 8 years
	There is a possibility of faulty fan, but that would be very... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Most likely where the cables exit the heater cartridge; just... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Check the motor pulley. There should be a couple of millime... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Apologies; I dragged the wrong file... Now corrected. For ... Dans le forum Print tips (Archive)	il y a 8 years
	What slicer did you use for that print? Can you zip up and ... Dans le forum Others (Archive)	il y a 8 years
	Well if the pulses to the bed and extruder disturbs the meas... Dans le forum Others (Archive)	il y a 8 years
	Glue stick on the bed really does assist with adhesion. But... Dans le forum Others (Archive)	il y a 8 years
	A few things I would try: Reducing the filament feed tensio... Dans le forum Others (Archive)	il y a 8 years
	Yeah. See attached. That is what I am currently using, but... Dans le forum Print tips (Archive)	il y a 8 years
	All the settings are at the start of the GCode file. Looks ... Dans le forum Others (Archive)	il y a 8 years
	Jeff There is also one more thing to consider and that is a... Dans le forum Prusa i3 kit (Archive)	il y a 8 years

Page 96 / 281 Précédent Suivant

Statistiques du forum

585 Forums

68.4 K Sujets

478.8 K Messages

9 En-ligne

76.3 K Membres

Le dernier des messages: First non-support layer infill is very thin, and isn't reaching the perimeters Notre nouveau membre: rhn Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé