PJR – Aktywność – Prusa3D Forum

Notifications

Clear all

PJR

Grupa: Moderator

Dołączył: 2015/06/01

Tytuł: Antient Member Moderator

	Yes. You certainly need the rear extruder and cable support... In forum Others (Archive)	8 years temu
	Was the PTFE tube too long or was it not seated correctly in... In forum Others (Archive)	8 years temu
	In Slic3r, I have now chosen "Prusa PLA 1.75 mm (modified)" ... In forum Others (Archive)	8 years temu
	Not _obvious_ . Totally agree on that.It is the logical th... In forum Others (Archive)	8 years temu
	Thomas SORRY 🙄 But ir was all to do with the extrud... In forum Prusa i3 kit (Archive)	8 years temu
	Jeff Did you see the purge line? Doesn't look right to me:... In forum Others (Archive)	8 years temu
	you're right Peter, but do you believe that this is the caus... In forum Others (Archive)	8 years temu
	No changing the extrusion multiplier will only reduce the vo... In forum Others (Archive)	8 years temu
	OK, there's something not right in your GCode settings. App... In forum Others (Archive)	8 years temu
	There is a possibility of faulty fan, but that would be very... In forum Prusa i3 kit (Archive)	8 years temu
	Most likely where the cables exit the heater cartridge; just... In forum Prusa i3 kit (Archive)	8 years temu
	Check the motor pulley. There should be a couple of millime... In forum Prusa i3 kit (Archive)	8 years temu
	Apologies; I dragged the wrong file... Now corrected. For ... In forum Print tips (Archive)	8 years temu
	What slicer did you use for that print? Can you zip up and ... In forum Others (Archive)	8 years temu
	Well if the pulses to the bed and extruder disturbs the meas... In forum Others (Archive)	8 years temu
	Glue stick on the bed really does assist with adhesion. But... In forum Others (Archive)	8 years temu
	A few things I would try: Reducing the filament feed tensio... In forum Others (Archive)	8 years temu
	Yeah. See attached. That is what I am currently using, but... In forum Print tips (Archive)	8 years temu
	All the settings are at the start of the GCode file. Looks ... In forum Others (Archive)	8 years temu
	Jeff There is also one more thing to consider and that is a... In forum Prusa i3 kit (Archive)	8 years temu

Strona 96 / 281 Wstecz Następny

Statystyki Forum

585 Fora

68.4 K Tematy

478.8 K Posty

9 Online

76.3 K Członkowie

Ostatni Post: First non-support layer infill is very thin, and isn't reaching the perimeters Najnowszy użytkownik:: rhn Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte