|
Thanks everyone, that's the information I was looking for. I... In forum Others (Archive) |
9 years ago |
|
Travis
That's good and it is an indicator that there is pos... In forum Assembly and first prints troubleshooting |
9 years ago |
|
If it's working then leave it.
Before the new heat break wa... In forum Others (Archive) |
9 years ago |
|
Yes, this has been reported a few times and has happened to ... In forum Others (Archive) |
9 years ago |
|
It needs to be there on every tool change simply to ensure t... In forum Software (Archive) |
9 years ago |
|
These?:
They needs to be self-lubricating, so brass or nyl... In forum Improvements (Archive) |
9 years ago |
|
OK, so the tempered glass is for the Mk1 (not Mk2); it is a ... In forum Others (Archive) |
9 years ago |
|
Yeah.
If i is equal to 0 carry out the next part else carry... In forum Software (Archive) |
9 years ago |
|
I've used slic3r for almost 1 year and am looking at matterc... In forum Software (Archive) |
9 years ago |
|
Yup, the timeout values in OctoPrint were set small, which c... In forum Software (Archive) |
9 years ago |
|
Unfortunately I couldn't use it because my e3 is not working... In forum Assembly and first prints troubleshooting |
9 years ago |
|
Yeah, I used 2.5mm^2 speaker cable. Bit stiff, but it's bee... In forum Others (Archive) |
9 years ago |
|
Most likely the screw which holds the thermistor in the heat... In forum Others (Archive) |
9 years ago |
|
As you have been printing fine for a while, I would check an... In forum Print tips (Archive) |
9 years ago |
|
Hi there, found the same model. I think it's awesome and a c... In forum Print tips (Archive) |
9 years ago |
|
The top of the cooling tube should move freely in the MUX. ... In forum Others (Archive) |
9 years ago |
|
I will research what the recommended range is regarding spee... In forum Assembly and first prints troubleshooting |
9 years ago |
|
Where did I miss the part about loosening the heat break?
Y... In forum Others (Archive) |
9 years ago |
|
Simply add the following line to the start G-Code:
M201 X15... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Travis
It also looks as though you have some issues with th... In forum Assembly and first prints troubleshooting |
9 years ago |
