|
When concrete drys, it puts out a lot of water. PLA is bio... In forum Others (Archive) |
7 years ago |
|
I installed the hardened steel nozzle on the printer that di... In forum Others (Archive) |
7 years ago |
|
Octoprint Settings/Printer Profiles/Edit/Print Bed and Build... In forum Software (Archive) |
7 years ago |
|
Yeah, I think I would have run it with 0.2 to 0.8 and then a... In forum Print tips (Archive) |
7 years ago |
|
Your eyes are the best judge...
But in all honesty, I reall... In forum Print tips (Archive) |
7 years ago |
|
I'm currently using this one with pretty good results:
Ye... In forum Improvements (Archive) |
7 years ago |
|
You may find that you need different preload values when pri... In forum Print tips (Archive) |
7 years ago |
|
Unfortunately, I cleaned out my PC a couple of weeks ago and... In forum Improvements (Archive) |
7 years ago |
|
This was a work-around introduced on these forums by us user... In forum Others (Archive) |
7 years ago |
|
Don't know if you looked at my thread when I was having simi... In forum Others (Archive) |
7 years ago |
|
I too use this on both my printers, but I removed the baffle... In forum Improvements (Archive) |
7 years ago |
|
Is lifting the nozze by 250 microns is necessary? Or whats t... In forum Print tips (Archive) |
7 years ago |
|
I've never heard about the cold pull before, but the interne... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Manu, not a problem.
Ensure there is a G92 E0 before the pr... In forum Print tips (Archive) |
7 years ago |
|
I think you may want to try a couple of "cold pulls" and als... In forum Prusa i3 kit (Archive) |
7 years ago |
|
First - thank you VERY much for assisting with this, you are... In forum Hardware, firmware and software help |
7 years ago |
|
Material? Temp? First layer height?
Does the extruder s... In forum Prusa i3 kit (Archive) |
7 years ago |
|
I don't usually go to third-party sites to view images; it's... In forum Hardware, firmware and software help |
7 years ago |
|
You could try a 1.8mm drill bit, by hand twisting slowly as ... In forum Others (Archive) |
7 years ago |
|
The top of the tube should move around and self-centre.
Of ... In forum Others (Archive) |
7 years ago |
