|
The current unload retraction is split into several bits, lo... In forum Hardware, firmware and software help |
9 years ago |
|
There is thermal paste between heat break and heat sink.
Th... In forum Others (Archive) |
9 years ago |
|
Ok I removed that line and now the skirt is printing correct... In forum Others (Archive) |
9 years ago |
|
Thank you for the tip! Most useful, no leaking before the st... In forum Assembly and first prints troubleshooting |
9 years ago |
|
You have 2 x 4mm retractions after the initial purge line an... In forum Others (Archive) |
9 years ago |
|
I am not able to upload any files besides pictures for some ... In forum Others (Archive) |
9 years ago |
|
Sorry, I don't go to third-party sites. Not really any need... In forum Others (Archive) |
9 years ago |
|
Slic3r Printer Profile.
Peter In forum Others (Archive) |
9 years ago |
|
Sounds as though you are using the MK2 printer profile inste... In forum Others (Archive) |
9 years ago |
|
Thanks, but I'm not clear on what stringing is. Could you po... In forum Others (Archive) |
9 years ago |
|
I just sliced with Slic3r PE and noticed there's no retracti... In forum Prusa i3 kit (Archive) |
9 years ago |
|
So is there a way to contact support other than the online c... In forum Assembly and first prints troubleshooting |
9 years ago |
|
Can you post your end G-code.
I have a feeling that you may... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Most likely cause: blockage due to stringing.
See this thre... In forum Others (Archive) |
9 years ago |
|
Slightly unrelated, is there a way to remove the tubes from ... In forum Others (Archive) |
9 years ago |
|
I always tell myself I'll be careful and not hit the fan but... In forum Others (Archive) |
9 years ago |
|
In that case, there's another issue happening elsewhere.
Ca... In forum Others (Archive) |
9 years ago |
|
Broke my cooling fan in the process
Done that a few time... In forum Others (Archive) |
9 years ago |
|
Remove the nozzle, let everything cool down, then remove the... In forum Others (Archive) |
9 years ago |
|
There are a few ways to overcome stringing, the main ones be... In forum Others (Archive) |
9 years ago |
