PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Todd Looking at your third photo (the printer), I see that ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Luc Can you please let me have a link to that file; I wi... Dans le forum Print tips (Archive)	il y a 10 years
	Hi Todd Firstly don't despair! I have both a clone and an ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Ruud One more thought on this issue - I have had a look at ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Richard The correct orientation is with the wires and he... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ruud See my posts in the new topic you created. Peter Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Ruud I think this may not be good news. Firstly, check t... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ruud OK, one thing at a time now; process of elimination... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Jacob I keep looking at your video to see if there is an... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ruud Great news that it was only a fuse. I hope you are... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Davis The pink "bullseye" on Pronterface centralises bot... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Roman I was just looking at the MAX_TEMP setting before ... Dans le forum Software (Archive)	il y a 10 years
	Amanda Yes, the 255 degrees is a correct figure, although A... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Josef That's what I had read into it and was referring to (... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Josef Yes, I did reply to your email. 5.36 ohms. Did y... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Josef Thanks for your input. The aluminium bed is about... Dans le forum Print tips (Archive)	il y a 10 years
	Hi Robert That's very nice; I might give that a go. Not en... Dans le forum Awesome prints (Hall Of Fame)	il y a 10 years
	Now I'm going to change my opinion... I have previously use... Dans le forum Print tips (Archive)	il y a 10 years
	Markus/David Having now built my printer, I would be inclin... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Angus Have you had any luck getting working as yet? Hav... Dans le forum Prusa i3 kit (Archive)	il y a 10 years

Page 278 / 281 Précédent Suivant

Statistiques du forum

598 Forums

71 K Sujets

497.7 K Messages

13 En-ligne

82.3 K Membres

Le dernier des messages: Filament fails to feed after ~45 minutes consistently. Notre nouveau membre: Teen Patti Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé