|
Hi Ruud
OK, so it's good that you have a voltage at the hea... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Err... 3 hours 30 minutes...
But is was my second printer.... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Roman
Yes, I had seen that thanks, but I don't think woo... En el foro Awesome prints (Hall Of Fame) |
hace 10 years |
|
OK Hans, not be careful with the assembly. Take your time a... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
First print with wood En el foro Awesome prints (Hall Of Fame) |
hace 10 years |
|
Hans, you are so lucky. Excluding shipping, that's still ch... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Roman
Thanks for enlightening me. My mistake; apologies... En el foro Improvements (Archive) |
hace 10 years |
|
Markus
The Prusa i3 Original 1.75mm should handle flex mate... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Markus
Below is my Cura INI file (Zipped). This is for ... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Markus
Great news and thanks for letting us know.
Enjoy... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Todd
There are 2 slicers I use which work well for me: ... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Jens
4 things to check:
1. Make sure the hot bed is th... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Luc
Apparently, I can add the files as an attachment as a Z... En el foro Print tips (Archive) |
hace 10 years |
|
Hi Luc
Sorry, I am a tad old-fashioned... No OneDrive.
I ... En el foro Print tips (Archive) |
hace 10 years |
|
Hi Todd
Try what I have suggested and please report back. ... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Hi Luc
You were getting a connection. Try this link: ftp:/... En el foro Print tips (Archive) |
hace 10 years |
|
Luc
There are a couple of gcode files on my FTP, one for PL... En el foro Print tips (Archive) |
hace 10 years |
|
Luc
I think I can see a problem; there are a couple of smal... En el foro Print tips (Archive) |
hace 10 years |
|
Hi
That is nice, but unfortunately, there is one problem I... En el foro Improvements (Archive) |
hace 10 years |
|
Hi Luc
Yes there are a couple of errors found with KISSlice... En el foro Print tips (Archive) |
hace 10 years |
