|
Hi Peter
Sorry, I didn't explain the temperature drop and r... In forum Print tips (Archive) |
10 years ago |
|
Here's a photo of my clip positions:
Peter In forum Prusa i3 kit (Archive) |
10 years ago |
|
Oh, and looking at your picture, it does look as though the ... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Constantine and welcome to the forums.
I see you have do... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Pleasure. Unfortunately, I started to have the same issue a... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Alexander
If you are running with the standard printer f... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Yeah, but the forum didn't used to be like it is now 😉 😉 In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi
Yes, I have seen his videos. Firstly, Bowden extruders ... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Alexander
Nice job. Yes, you should tighten up the nozz... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Nathan
Yeah, it does look very much as though the pulley... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Apologies; that response was with regards to your firmware f... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Cable management is the key to this.
The cables must be org... In forum Prusa i3 kit (Archive) |
10 years ago |
|
No, it's not incorrect. It's all to do will acceleration an... In forum Prusa i3 kit (Archive) |
10 years ago |
|
OK, just checked further into the feed rate.
The firmware d... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Actually, you would have to be printing very quick and thick... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi
I have no idea as I don't use Slic3r. Sorry.
Peter In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi
I have had this happen to me a while back. I cleaned t... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi
No, unfortunately not. If you look at previous posts, t... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Interesting. The print finished after 18 hours and 20 minut... In forum Prusa i3 kit (Archive) |
10 years ago |
|
Hi Roger
I started a print last evening. As soon as I sent... In forum Prusa i3 kit (Archive) |
10 years ago |
