|
Hi Nick
I think quite a few of us have those little holes. ... In forum Others (Archive) |
před 9 years |
|
Hi Ali
Ditto wnat David said.
i have managed to get very ... In forum Others (Archive) |
před 9 years |
|
Shree
It may be possible to use the filament you have; you ... In forum Others (Archive) |
před 9 years |
|
Yeah, I tried the 3.0.4 Beta yesterday.
My front right prob... In forum Others (Archive) |
před 9 years |
|
David
That should be OK. Are you angling the end of the fi... In forum Others (Archive) |
před 9 years |
|
So, when you read the data from the STL file, would it oe po... In forum Software (Archive) |
před 9 years |
|
The morale of the story is ...
Don't use floating point ari... In forum Software (Archive) |
před 9 years |
|
Yeah, it works for me without the G87 code via OctoPrint.
P... In forum Others (Archive) |
před 9 years |
|
Well, today I took the plunge and downloaded this firmware.
... In forum Others (Archive) |
před 9 years |
|
Hi Shree
Firstly, I think the nameplate is better printed f... In forum Others (Archive) |
před 9 years |
|
David
Also as I mentioned in a different thread, the V2Cali... In forum Others (Archive) |
před 9 years |
|
Just found it...
Octoprint/Settings/Serial connection/Advan... In forum Others (Archive) |
před 9 years |
|
Hi Marc
Yes, it is possible for the Z axis to rise. When it... In forum Others (Archive) |
před 9 years |
|
Ahhh
I think there is a huge clue there.
I remember seei... In forum Others (Archive) |
před 9 years |
|
Richard
Thanks for the info. I haven't had this issue (yet... In forum Others (Archive) |
před 9 years |
|
Richard/Kevin
As Kevin has suggested, I do use a variety of... In forum Others (Archive) |
před 9 years |
|
In my opinion, the probe/bed calibration should always be ca... In forum Others (Archive) |
před 9 years |
|
Shree
This forum does accept ZIP files, so just use "Send T... In forum Others (Archive) |
před 9 years |
|
Maxim
Firstly, you have to download and install the drivers... In forum Others (Archive) |
před 9 years |
|
Hi Shree
Just noticed that you printed this vertically. An... In forum Others (Archive) |
před 9 years |
