Čeština
Fóra
Uživatelé
PJR
Aktivita
 
Notifications
Clear all
PJR
PJR
Skupina: Moderátor
Přidal se: 2015/06/01
Název: Antient Member Moderator
Profile Aktivita
That's because your part fan is not working. Check the conn...

In forum Prusa i3 kit (Archive)

 před 10 years
I used to reliably retract 3mm at 80mm/s on the Original Pru...

In forum Others (Archive)

 před 10 years
Sounds very much as though the 10mm threaded rods are not fu...

In forum Others (Archive)

 před 10 years
Kai There does seem to be an issue here with the assembly o...

In forum Prusa i3 kit (Archive)

 před 10 years
Yes, the G0 and G1 commands specify the feed rate in mm/min:...

In forum Others (Archive)

 před 10 years
Kevin In that case, you may want to invest also in smooth r...

In forum Prusa i3 kit (Archive)

 před 10 years
That is great news. Well done! I will say that since I set...

In forum Others (Archive)

 před 10 years
Andreas I note that Josef has all his default settings to p...

In forum Others (Archive)

 před 10 years
Andreas The printer will need to be calibrated perfectly es...

In forum Others (Archive)

 před 10 years
Kevin I don't think there is much load on these bearings at...

In forum Prusa i3 kit (Archive)

 před 10 years
India Pale Ale Now more easily available here in Slovenia t...

In forum Prusa i3 kit (Archive)

 před 10 years
I saw that and figured I'd be better off waiting for the off...

In forum Software (Archive)

 před 10 years
Hi Kevin Environment matters. This used to happen to me a ...

In forum Prusa i3 kit (Archive)

 před 10 years
Yesterday, Anderson posted some Cura profiles for the Mk2 wi...

In forum Software (Archive)

 před 10 years
You suggested to use 3 perimeters but you're using 20? No -...

In forum Software (Archive)

 před 10 years
One more thought... After a discussion about print speeds o...

In forum Software (Archive)

 před 10 years
David In my opinion, although some slicers do attempt to ha...

In forum Others (Archive)

 před 10 years
Hi Paul UPS is usually a great shipping company and I think...

In forum Others (Archive)

 před 10 years
No idea why that would happen. Of course, it does happen to...

In forum Software (Archive)

 před 10 years
The perimeter value (currently set to 2) - increase that to ...

In forum Software (Archive)

 před 10 years
Stránka 204 / 281
Share: