PJR – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

PJR

Gruppe: Moderator

Beigetreten: 2015/06/01

Titel: Antient Member Moderator

	That's because your part fan is not working. Check the conn... Im Forum Prusa i3 kit (Archive)	Vor 10 years
	I used to reliably retract 3mm at 80mm/s on the Original Pru... Im Forum Others (Archive)	Vor 10 years
	Sounds very much as though the 10mm threaded rods are not fu... Im Forum Others (Archive)	Vor 10 years
	Kai There does seem to be an issue here with the assembly o... Im Forum Prusa i3 kit (Archive)	Vor 10 years
	Yes, the G0 and G1 commands specify the feed rate in mm/min:... Im Forum Others (Archive)	Vor 10 years
	Kevin In that case, you may want to invest also in smooth r... Im Forum Prusa i3 kit (Archive)	Vor 10 years
	That is great news. Well done! I will say that since I set... Im Forum Others (Archive)	Vor 10 years
	Andreas I note that Josef has all his default settings to p... Im Forum Others (Archive)	Vor 10 years
	Andreas The printer will need to be calibrated perfectly es... Im Forum Others (Archive)	Vor 10 years
	Kevin I don't think there is much load on these bearings at... Im Forum Prusa i3 kit (Archive)	Vor 10 years
	India Pale Ale Now more easily available here in Slovenia t... Im Forum Prusa i3 kit (Archive)	Vor 10 years
	I saw that and figured I'd be better off waiting for the off... Im Forum Software (Archive)	Vor 10 years
	Hi Kevin Environment matters. This used to happen to me a ... Im Forum Prusa i3 kit (Archive)	Vor 10 years
	Yesterday, Anderson posted some Cura profiles for the Mk2 wi... Im Forum Software (Archive)	Vor 10 years
	You suggested to use 3 perimeters but you're using 20? No -... Im Forum Software (Archive)	Vor 10 years
	One more thought... After a discussion about print speeds o... Im Forum Software (Archive)	Vor 10 years
	David In my opinion, although some slicers do attempt to ha... Im Forum Others (Archive)	Vor 10 years
	Hi Paul UPS is usually a great shipping company and I think... Im Forum Others (Archive)	Vor 10 years
	No idea why that would happen. Of course, it does happen to... Im Forum Software (Archive)	Vor 10 years
	The perimeter value (currently set to 2) - increase that to ... Im Forum Software (Archive)	Vor 10 years

Seite 204 / 281 Vorherige Nächstes

Forums-Statistiken

595 Foren

70.6 K Themen

494.5 K Beiträge

14 Online

82 K Mitglieder

Letzter Beitrag: Printer did not stop when it ran out of filament Unser neuestes Mitglied: MiniCity Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen