|
Hi Kai
From what I can tell, the thermistors are the same, ... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
OK, this is what I have done:
1. opened the firmware folde... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Jeremy
Attached is the firmware for a Mk1 with lead screws.... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
You want to stay with the Lite6 or upgrade to the V6 (from t... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Jeremy
As a software engineer, I have been "playing" with t... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Apologies, you are indeed correct.
It seems that last time ... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
OK, so nylon is a supposedly "supported" material, so I gues... En el foro Others (Archive) |
hace 10 years |
|
Here are some tips for printing with nylon:
Enjoy...
Pete... En el foro Others (Archive) |
hace 10 years |
|
Jeremy
As I stated earlier, both Mk1 and Mk2 firmware use t... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
but the guts are Prusa
...
I confirmed that all 3 input rail... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Just had a look at the RAMBo schematic. It would appear tha... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Jeremy
Just checked the firmware; for both Mk1 and Mk2 all ... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Jeremy
I have already posted notes on how to amend the firm... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Dave
Thinking about your problem, it seems as though you ha... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Gene
Being mad really won't help.
Remove the glass and hom... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Robert
The first sensor position is not located at 0,0 so d... En el foro Others (Archive) |
hace 10 years |
|
Hi Gene
I presume this is a Mk1? Calibration is quite diff... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Jeremy
Yes, it will work, but you will have to change the Z... En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Dave
What firmware version are you running?
Peter En el foro Prusa i3 kit (Archive) |
hace 10 years |
|
Try printing in high power mode.
Peter En el foro Prusa i3 kit (Archive) |
hace 10 years |
