Aktivität
 
Benachrichtigungen
Alles löschen
PJR
PJR
Gruppe: Moderator
Beigetreten: 2015/06/01
Titel: Antient Member Moderator
Ayork My re-designed hot end housing was printed in PLA. T...

Im Forum Improvements (Archive)

Vor 10 years
Will The settings are in Configuration_prusa.h: currently ...

Im Forum Improvements (Archive)

Vor 10 years
3.0.5RC is here: The Z_MIN setting in this version is 0.15...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
No difference :-). Not an unexpected result, but I guess wo...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
Kai First upgrade the firmware to 3.0.5 RC. It has its own...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
Marco I think that when you go further in the build, you wi...

Im Forum Others (Archive)

Vor 10 years
I also see posts here that say that more than -1mm is genera...

Im Forum Others (Archive)

Vor 10 years
I believe that customer support has on one occasion (reporte...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
Did you run the self test? this will check the end stops. A...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
Bed adhesion issues fixed by one of more of the following: ...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
Kevin The difference is the motor current settings only. I...

Im Forum Software (Archive)

Vor 10 years
Kevin The latest firmware (3.0.5RC) does have thermal runaw...

Im Forum Software (Archive)

Vor 10 years
Christophe That would be a real pain in the a55 and slow th...

Im Forum Software (Archive)

Vor 10 years
Yeah. Worst case brace from the rear Y corners to the top o...

Im Forum Others (Archive)

Vor 10 years
James add the following to the "End GCode" section within t...

Im Forum Print tips (Archive)

Vor 10 years
Actually that is a very good use of aluminium extrusions and...

Im Forum Others (Archive)

Vor 10 years
Justin Which connector is burned? The connector from the P...

Im Forum Others (Archive)

Vor 10 years
Curtis Yes, the graph does show an exceedingly stable extru...

Im Forum Others (Archive)

Vor 10 years
Curtis There would be no alignment issues; the nozzle must ...

Im Forum Prusa i3 kit (Archive)

Vor 10 years
The Duet does sound good and can go upto 84MHz and supports ...

Im Forum Improvements (Archive)

Vor 10 years
Seite 199 / 281
Teilen: