PJR – Aktivita – Prusa3D Forum

Notifications

Clear all

PJR

Skupina: Moderátor

Přidal se: 2015/06/01

Název: Antient Member Moderator

	Ayork My re-designed hot end housing was printed in PLA. T... In forum Improvements (Archive)	před 10 years
	Will The settings are in Configuration_prusa.h: currently ... In forum Improvements (Archive)	před 10 years
	3.0.5RC is here: The Z_MIN setting in this version is 0.15... In forum Prusa i3 kit (Archive)	před 10 years
	No difference :-). Not an unexpected result, but I guess wo... In forum Prusa i3 kit (Archive)	před 10 years
	Kai First upgrade the firmware to 3.0.5 RC. It has its own... In forum Prusa i3 kit (Archive)	před 10 years
	Marco I think that when you go further in the build, you wi... In forum Others (Archive)	před 10 years
	I also see posts here that say that more than -1mm is genera... In forum Others (Archive)	před 10 years
	I believe that customer support has on one occasion (reporte... In forum Prusa i3 kit (Archive)	před 10 years
	Did you run the self test? this will check the end stops. A... In forum Prusa i3 kit (Archive)	před 10 years
	Bed adhesion issues fixed by one of more of the following: ... In forum Prusa i3 kit (Archive)	před 10 years
	Kevin The difference is the motor current settings only. I... In forum Software (Archive)	před 10 years
	Kevin The latest firmware (3.0.5RC) does have thermal runaw... In forum Software (Archive)	před 10 years
	Christophe That would be a real pain in the a55 and slow th... In forum Software (Archive)	před 10 years
	Yeah. Worst case brace from the rear Y corners to the top o... In forum Others (Archive)	před 10 years
	James add the following to the "End GCode" section within t... In forum Print tips (Archive)	před 10 years
	Actually that is a very good use of aluminium extrusions and... In forum Others (Archive)	před 10 years
	Justin Which connector is burned? The connector from the P... In forum Others (Archive)	před 10 years
	Curtis Yes, the graph does show an exceedingly stable extru... In forum Others (Archive)	před 10 years
	Curtis There would be no alignment issues; the nozzle must ... In forum Prusa i3 kit (Archive)	před 10 years
	The Duet does sound good and can go upto 84MHz and supports ... In forum Improvements (Archive)	před 10 years

Stránka 199 / 281 Předchozí Další

Fórum Statistiky

595 Fóra

70.6 K Témata

494.3 K Příspěvky

14 Online

82 K Uživatelé

Poslední Příspěvek: Humidity Control For Filament Storage - How Tight Does a Container Have to Be? Nový Uživatel: MiniCity Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed